Xylem HYDROVAR (HV2.1 - 3.45) - Manual (Page 40)

40
d) Active MODE = Manual Control:
1. ITT INDUSTRIES
Frequency XX.X Hz
1 st display at Mode Manual Control local.
Continue by pressing the ¾-button
2. MANUAL CONTROL
X.X Hz X.XX BAR Set the desired set pressure with either Ï or Ð and
then shortly press the ¾-button.
Press the ¾ button to change to the next parameter (menu 3)
The following parameters of the main menu are valid for all selected Modes!
3. AUTO - START
ON
Select (ON) with Ï or (OFF) with the Ð button.
If AUTO-START = ON, the HYDROVAR starts automatically after a remedy of a failure or
disconnection of the power supply.
If AUTO-START = OFF, the HYDROVAR won’t start automatically after a remedy of a failure or
disconnection of the power supply.
After remedy of the failure or reconnection of the power supply the following message is
shown:
3.1 NO AUTOSTART
disable inverter
To restart the HYDROVAR, press Ð to quit and Ï to
restart.
Press the ¾ button to change to the next parameter