YSI DIQ/S 182-PR System 182 - Manual (Page 112)

PROFIBUS connection System 182
7 - 2 ba76024e01 02/2012
 Have admissible bus parameters been set only? If you are in doubt
set them to default values.
 Is it guaranteed that the PROFIBUS master has consistent access
to the 16 byte sensor data structure?
Note for Siemens PLC with programming language STEP7:
The following commands have to be used for consistent access:
– SFC15 (for writing)
– SFC14 (for reading)
 After commissioning:
Do all devices signal error-free behavior?
(DIQ/S 182-PR: status "Online" in the measured value and status
display).
7.2 Connecting the PROFIBUS cable
The PROFIBUS cable is connected to the DIQ/S 182-PR using a 9-pin
D-SUB connector on the top of the housing. As connector on the cable
side, we exclusively recommend one of the following two connectors.
Manufacturer: Phoenix Contact GmbH & Co. KG
Flachsmarkt 8
32825 Blomberg
Germany
http://www.phoenixcontact.com
Types: VS-09-PROFB-SC
(Phoenix article no. 1654549, with screwed contacts,
available from YSI under order number 902 888Y)
or: VS-09-PROFB-SP
(Phoenix article no. 1654345, with spring contacts)
To remove the blind plug, lift the safety bracket with a suitable screw
driver at both clamps on the left and right side (see Fig. 7-1).