YSI Vertical Profiler Systems - Manual (Page 76)

YSI Profiler System USER Manual
Fixed Mount Depth Profiler – Not a Floating Platform
Figure 6-5 Dock-mount Profiler (fixed mount version)
The YSI Profiler is occasionally used in a fixed mount configuration. The Winch Assembly is
separately attached. The Controller Assembly involves the same electronics, but packaged in a
standard NEMA enclosure. Solar panels may be replaced by regulator that is AC powered. PVC
pipe helps guide the sonde from the surface to the winch drum. Antenna (not visible) for RF or
cellular modem attached to pole.
Each deployment is slightly different. If you are unfamiliar with these types of deployments,
write down your requirements, environmental conditions during the season, concerns you may
have about stability, security and any other issues. Endeco/YSI should be able to help you with
your application and deployment. Call or write. Contact information is in Appendix A.
6.2 Testing Communications
YSI Floating Profiler platforms may use a variety of wireless communications options. Each has
its own distinctive set of issues.
In Section 5 you learned to set up modem communications and you learned some about using a
similar approach to set up communication through an IP address for Web access. If you have a
laptop computer, the system can be tested prior to moving to the remote site. This test is worth
the time, but is no substitute for testing on site. If possible, verify that your communications
equipment will work on site prior to pre-deployment checkout. Contact your cellular carrier or
RF radio manufacturer to inquire about reception at the remote site you intend to use.
YSI Environmental 669523 Rev B Page 6-3