YSI Vertical Profiler Systems - Manual (Page 93)

YSI Profiler System USER Manual
privileges to access that folder. To obtain this information you may need to contact your
IT manager or the person in charge of the FTP site.
Next click the Connect button to test the connection. If the connection fails, check the messages
displayed in the lower text window. The messages will identify the reason for failure. See Figure
7-16.
Figure 7-16 Test Connection for FTP Site
Once you are connected to the FTP site and you have appropriate privileges for the User Name
you entered, you can continue browsing for the correct folder path or create a new folder on the
FTP site by clicking the New Dir button.
Click the Return button to return to Configure Single Station window.
Then, click the OK button to return back to the Configure Automated Stations window. See
Figure 7-17 below and read the next text below to complete your setup.
Note: If any error occurred during the Automated Station setup a description of the error will
appear in the Error text window and the OK and Apply buttons would be disabled.
Now you have a station listed (Quabbin) and selected for automatic graphic creation. This is
shown by the check mark before the station name. You may want to turn off an individual station
from creating graphics when servicing the site or if an FTP server is down. To do so select the
individual station name and click the Turn ON/OFF button. If the station is offline the check
mark will disappear.
YSI Environmental 669523 Rev B Page 7-12