Extron Electronics TLP 710CV User Guide - Manual (Page 11)

Mounting
This section provides detailed instructions for mounting the TLP 710CV in a table and installing
the AAPs. It covers:
z Planning
z Tools Required for Installation
z Included Parts
z Cutting the Table
z Mounting the TLP 710CV Enclosure
z Running Cables
z Installing Cable Retractors
z Installing Power Modules
z Preparing and Installing the AAP Assemblies
Planning
Before making any cuts, select the best location for the TLP 710CV. Keep in mind the following:
‡ Ensure that the edge that opens on the lid is oriented correctly.
‡ Ensure there is enough space for all the system cables and components, above and below
the table. Take account of:
z Clearances for under-table cabling, especially if the cable has a large bend radius.
z Adequate space below the table for cable retractors if they are to be installed.
z
The number and type of AAPs required for the installation.
z
The location of devices that connect to the AAPs either above or below the table.
‡ Verify that you have the correct template or dimensions.
‡ Decide on the method for cutting a hole in the table. There are three methods available:
z
Hand router and template, which requires a router template (part number
70-980-01), which must be purchased separately
z
CNC wood router, which must be programmed with the correct dimensions.
z
Jigsaw, which requires a paper template (available from the Extron website ).
The hand router using the routing template or the CNC wood router are the most accurate
methods for cutting the hole. Either one of these methods is recommended by Extron. The
jigsaw is less accurate but is also acceptable.
‡ Check all relevant regulations.
z Ensure the installation complies with local, state, and national building and electrical
codes.
z
Ensure the installation complies with the Americans with Disabilities Act or other
accessibility requirements.
TLP 710CV • Mounting 5