Extron Electronics TLP 710CV User Guide - Manual (Page 13)

Cutting the Table
Cutout Dimensions
CAUTIONS: • The table should be cut only by licensed and bonded craftspeople.
• Make certain the correct cutout dimensions are being used before proceeding
to the next step. Extron is not responsible for incorrectly cut mounting holes.
• The surfaces of the Cable Cubby enclosure have screws and other protruding
hardware that could damage fine furniture. Do not rest the enclosure on
unprotected furniture.
• Ensure the table surface is at least 0.375 inches (0.95 cm) thick.
There are three alternative methods of making the hole for the TLP 710CV:
z If using a hand router, you should purchase the TLP 710CV routing template (part number
70-980-01).
z If using a CNC wood router, use the exact cut-out dimensions (see below).
z If using a reciprocating saw or jigsaw use the paper cut-out template.
Cutting the Surface
WARNING: To avoid eye injury, wear safety glasses when operating power equipment.
Be certain the cut is laid out in exactly the desired location and the edge that opens on the lid
is correctly oriented. After verifying and checking dimensions, cut a hole in the surface of the
furniture where the enclosure will be installed.
Router with Routing Template
If using a routing template, make
sure it is the correct template for the
TLP 710CV (part number 70-980-01).
For complete instructions, see the
Routing Template User Guide, available at
www.extron.com .
NOTE: The metal router guide must be purchased
separately. It is reusable and should not be
discarded when the installation is complete.
CNC Router
If using a CNC router, enter the correct dimensions for the TLP 710CV:
8.90 +0.00/-0.02 inches W x 7.1 +0.00/-0.02 inches D
22.61 +0.00/-0.05 cm W x 18.03 +0.00/-0.05 cm D
NOTE: The width dimension (underlined) refers to the
side with AAP access.
Reciprocating Saw or Jigsaw
If using a reciprocating saw or jigsaw, make
sure to use the paper cutout template for the
TLP 710CV. The template is available on the
Extron website (
www.extron.com ).
HSA 200 USER A
CCESS
HSA 200 CABLE C
UBBY 30
0
CABLE CUBBY
300
USER A
CCESS
Cut-Out
Template
for the Extron TLP 710C
V
Outer E dge of
Trim Ring
(Do no t cut th is lin e.)
1. Confi rm th e pr oduct to b e inst alled.
2. Remo ve th e surf
ace cu t-out area
(g ray) fr om the
tem plate .
3. Mark the positio
n on the w all or
furnit ure w here t he TLP 710
MV
is be ing in sta lled.
4. Cu t the ope ning.
P/N 68 -2046-
01 R ev. B
Pag e s ize : 11" x 17
"
Print scale 1:
1
Do not shrink
.
P/N P/
TLP 710CV • Mounting 7