Preparing and installing the aap assemblies, Installing aaps, Install aaps – Extron Electronics TLP 710CV User Guide User Manual
Page 15: Install the aap assembly, Into the cable cubby enclosur
2.
Run the cable or conduit to a convenient junction box. Extron recommends the circuit be
attached to a junction box that is directly wired to the main circuit. The AC power module
does not have a fuse.
Preparing and Installing the AAP Assemblies
The AAP assembly organizes the AAPs onto a frame that can easily be inserted or removed
from the TLP 710CV frame. Pass-through and blank AAP plates are provided with the
TLP 710CV. Active or passive AAPs must be purchased separately. For the complete range of
If neither power modules nor cable retractors are installed, up to 11 AAPs can be
accommodated. Cable retractors, if installed, occupy the space of two AAP slots. The power
modules occupy the space of two (US) or three (European or Universal) AAP slots.
AAP brackets are available in one-space, two-space, and three-space configurations. Decide the
location of each AAP prior to assembly. Pass-through AAPs provide direct cable connection and
must have the cable installed as they are being mounted on the brackets.
TIP: The recommended way to install the cables and AAPs is to populate the brackets with
AAP plates outside the enclosure as shown below, then install the populated AAP
assemblies into the enclosure.
NOTE: An extra column of AAP bracket mounting points is
available for use with TLP Single-space AAP mounting
brackets (part number 70-693-01). Single-space
brackets will not fit in any other location.
Rear Brackets
Front Brackets
Figure 3.
Preparing the AAP Assembly
Installing AAPs
1.
Determine how many AAPs will be used and how many front and rear brackets will be
needed. The brackets come in one-space, two-space, and three-space configurations. The
rear brackets are taller than the front brackets.
2.
Place the AAP onto the bracket. Ensure one end of the AAP is secured to a front bracket
and the other end is secured to a rear bracket. Whenever possible match the width of the
front and rear brackets.
NOTES: • Active, passive and pass-through AAPs can be mixed.
• Cables can be attached to the active or passive AAPs after assembly.
• Insert cables into each pass-through AAP before the next AAP is added.
The extra column
of mounting points
is for installing
single-space
AAP brackets.
TLP 710CV • Mounting
9