Extron Electronics TLP 710CV User Guide - Manual (Page 32)

3. From the same site, download the firmware for the TouchLink touchpanel. Click the
Download tab on the Extron home page and select the Firmware option.
Figure 21. Extron Web Page — Download Center
4. Navigate to the TLP 710CV firmware and click Download .
This downloads the firmware to your computer. Note the folder in which the firmware file
is saved.
5. Open the Extron Firmware Loader by clicking on the desktop icon.
6. Select TLP 710CV from the Device drop-down menu.
7. Select TCP/IP from the Connection Method drop-down menu.
8. Enter the IP address for the TLP 710CV, a Telnet port number (this will usually be 23), and a
password. Click
Connect .
9. In the New Firmware File “Path” pane, navigate to the file that was saved in step 4. Click
the
Add button. The main Firmware Loader screen opens with the TLP 710CV listed in the
device pane.
10. Click Begin . The firmware transfer begins and takes approximately three minutes. When
the Total Progress area shows “Completed”, select Exit from the File menu to exit
Firmware Loader.
Updating Firmware Using GUI Configurator
1. Set up the computer and touchpanel as described in steps 1 and 2 in the previous section
(
“Updating firmware using Extron Firmware Loader“ ). If necessary, install the Extron
Firmware Loader utility onto the computer (use the same method described in “Installing
the Software” ).
2. Find the firmware on the Extron website and download it to your computer, as described
in steps 3 and 4 in the previous section.
3. Open GUI Configurator to a new or existing project. Open the Firmware Update Manager
by clicking on
Firmware Update Manager... in the Tools menu.
Figure 22. Opening Firmware Loader from GUI Configurator
4. The program will automatically connect to the TLP 710CV. Follow the on-screen
instructions to upload the firmware.
TLP 710CV • Configuration Software 26