Extron Electronics TLP 710CV User Guide - Manual (Page 24)

Initial
Configuration
and Calibration
This section describes:
z How to Access the Internal On-screen Menus
z The Main , Volume , Time , Network , and Video screens
z The Touch Calibration Screen
How to Access the Internal On-screen Menus
When the TouchLink touchpanel first has power applied, the unit boots up and displays the
opening screen. To access the on-screen menus, press the
Menu button (see page 13).
The menus open at the Main screen. There are five different screens ( Main , Volume , Time ,
Network , and Video ) that can be selected by pressing the appropriate button at the left side
of the screen.
There is also an
Exit button at the bottom left corner of the screen. Pressing this button
applies and saves any changes and leaves the menu screens.
Main Screen
Main
Volume
Time
Network
Video
Exit
On Down Up
Sleep timer: 005 Min
Down Up
Backlight: 073%
Auto Backlight PoE
Active
Figure 11. Main Screen
Values can be changed by pressing the buttons to highlight them. Press the Down or Up buttons
to adjust the values or press the Auto Backlight button to toggle between Off and On . The
current setting is shown above the buttons.
The sleep timer determines how long the touchpanel will be inactive before it enters Sleep
mode, when the screen goes dark to save power. The time can be changed from 0 to 833
minutes. The time that is currently selected is shown above the buttons.
TLP 710CV • Initial Configuration and Calibration 18