Extron Electronics TLP 710CV User Guide - Manual (Page 12)

Tools Required for Installation
The following tools are required but not supplied:
Safety Glasses
Phillips Screw Driver
Tape Measure
1/4" Hex Nut Driver
Marking Pen
Square
Vacuum Cleaner
Included Parts
Open the shipping container and verify that all the components are present:
Table Clamps
Extron
Removal Tool
Zip Ties
#4−40 Screws
and Nuts
TLP 710CV
AC Power Module 1
Blank AAPs
Pass-thru AAPs
2 Pos
AAP Shelf Bracket Kits
(2 brackets/kit) 2
3 Pos 1 Pos
PWR LAN OUT LAN-IN
AMBE R GREEN BLINK
POWER ON POWE R ACTIVE LOAD ERRO R
Power over
Ethernet (PoE)
Injector
Extr on Extr on
With Power Module Without Power Module
AC Power Module 1 1 0
Pass-through AAPs 2,3 3 3
Blank AAPs 6 6
1 space Bracket Kit 0 1 4
2 space Bracket Kit 3 4
3 space Bracket Kit 1 1
NOTES: 1 Outside the US, see the Extron website to purchase a power module that is
suitable for your location.
2 Each AAP Bracket Kit consists of two brackets. The rear bracket is higher than
the front bracket and has two holes for screws.
3 Active or Passive AAPs are not provided and must be purchased separately (see
the Extron website ).
4 Single-space brackets can only be installed in one location (see the note and
figure on page 9).
TLP 710CV • Mounting 6