Configuration and calibration overview, Screen configuration and calibration, Installing software and firmware – Extron Electronics TLP 710CV User Guide User Manual
Page 23: Designing the screen layout, Linking control functions to screen objects, Configuration and calibration, Overview
Configuration
and Calibration
Overview
By now, the TLP 710CV must be installed in a suitable place, all necessary cables securely
attached, and the unit powered on. This section provides an overview of calibrating, designing
the screen layout, and adding functions to the touchscreen.
Screen Configuration and Calibration
1.
Press the
opens.
2.
Adjust values as required.
3.
Press the appropriate button on the edge of the screen to select the
menu and adjust the desired values from each menu.
4.
Press the
.
5.
Press the square that is colored green until it turns gray and the next square turns green.
When all four squares have been calibrated, the screen reopens to the
screen.
6.
Press the Exit button to save changes and leave the menus.
Installing Software and Firmware
You will need to install GUI Configurator (version 1.3 or later), Global Configurator (version 3.3
or later), and Firmware Loader on your computer. These programs are available on the DVD
that ships with the TLP 710CV and from the
Firmware can be upgraded by downloading it to your PC fr
. It can be
uploaded to the touchpanel using
1.
Check the
e for the TLP 710CV has been upgraded.
2.
to your PC and note the folder where it is saved.
3.
to the touchpanel by one of the available methods.
Designing the Screen Layout
1.
(version 1.3 or later) to design the graphical user interface
that will appear on the TouchLink touchpanel (see the GUI Configurator help file for
further information).
2.
Upload the graphical user interface
Linking Control Functions to Screen Objects
to associate the touchpanel with an IP Link controller and to assign
functions to the on-screen objects.
TLP 710CV • Calibration and Configuration Overview
17