Q.V.P. VAKUUM KLAMPING - Manual (Page 6)

5/6/98 - Klamping Instructions.cdr
KLAMPING DIAGRAMS
Right Angle Jig with
VAK Tape
Figure 6
Use a 1/2“ length of VAK-Tape
to keep the gate open or
closed.
Open
gate
Closed
Gate
Open
gate
Closed
Gate
Figure 5
Leave the paper backing on
the gate so that it can easily
swing to open and close the
vacuum area.
VAK-Tape
Work Piece
VAKuum Jig
Template
Table
Figure 8
Pin Routing: Simple, fast, tight,
gripping and speeds up production.
Vacuum
Work Piece
Figure 7 - VAK-Klamp to Hold Small Pieces
Recess the VAK-Tape so the
workpiece is pulled tight against the
baseplate covered with sandpaper.
Add pins or nail points to add
holding force and prevent lateral
movement.
Work Piece
VAKuum Jig VAKuum Jig
VAK-Tape
Vacuum
Vacuum
Work Piece
VAKuum Jig & Template
Table
Figure 9
Hand Routing: Workpiece held to table
with a VAKuum template.
Vacuum
Vacuum hole
Vacuum
VAK-Tape
On both faces of jig.