AT&T EP5632 - Manual (Page 31)

27
Bluetooth
NOTE: Connected
devices appear on the
Active Devices list
automatically.
Active Devices
Only devices on the
Active Devices list can establish
a Bluetooth connection with the telephone base.
Although two paired devices can be connected to
the telephone base, only one Bluetooth cellular
phone or headset can be on a call at a time.
To enter the Active Devices list:
1. Press the MENU softkey on the telephone base
while in idle mode.
2. Press the UP and DOWN NavKeys to highlight
Bluetooth, then press the SELECT softkey to enter
the
Bluetooth menu.
3. Press the DOWN NavKey to highlight Active
Devices, then press the SELECT softkey.
On the Active Devices list, you may see the
following status symbols:
• X in front of the device means that it is
disconnected.
•
P
in front of a device indicates that it is
connected to the telephone base.
• ))) in front of a device indicates that the
telephone base is trying to connect to that
device.
While on the Active Devices list, you can select:
• CONNECT - press the CONNECT softkey to
connect to a disconnected device.
• DISCONN - press the DISCONN softkey to
disconnect a device.
• INFO - press the INFO softkey to view the
current status and full name of a Bluetooth-
enabled device.
• OPTIONS - press the OPTIONS softkey to
replace or remove a device.
If you experience difficulty using your Bluetooth
device(s), make sure that the device is on and not
make sure that the device is on and not
connected to any other Bluetooth device. See
the
Troubleshooting section (page 94) for more
information.
SELECT
Bluetooth
Set up Cellular
Set up Headset
Active Devices
Active Devices
X 1 My Headset
P 2 John's Cell
CONNECT INFO OPTIONS
Main Menu
Call Log
Answering System
Bluetooth
SELECT
12:00 AM
REDIAL MENU CID
1 2