AT&T EP5632 User Manual
Page 51
47
System setup
Ringer Volume
You can choose one of the ringer volume levels on
the telephone base. The ringer can also be turned
off so the telephone base will not ring during
incoming calls.
To adjust the telephone base ringer volume:
1. Press the
MENU softkey in idle mode to enter
the main menu.
2. Press the
UP and DOWN NavKeys to select
Ringers, then press the SELECT softkey to enter
the
Ringers menu.
3. Press the
UP and DOWN NavKeys to highlight:
•
Ringer for HOME - set the ringer volume and
melody for the
HOME line.
•
Ringer for CELL 1 - set the ringer volume
and melody for the first connected cellular
phone on the
Active Devices list (page 27).
•
Ringer for CELL 2 - set the ringer volume and
melody for the second connected cellular
phone on the
Active Devices list (page 27).
4. Press the
SELECT softkey.
5. Press the
SELECT softkey again to select Ringer
Volume.
6. To set the ringer volume:
• Press the
UP and DOWN NavKeys, or
• Press the
LEFT and RIGHT NavKeys, or
• Press the
VOLUME on the telephone base.
-OR-
To turn off the telephone base ringer:
• Press the
OFF softkey, or
• Press the
DOWN NavKey, LEFT NavKey, or
DOWN volume key until Ringer Off is shown
on the display.
7. Press the
SET softkey to save the setting.
SET
Ringer Volume
Ringer Off
NOTE: Even if the
ringer volume is off, the
telephone base or handset
will ring at the lowest
volume setting during an
incoming intercom call.
Ringers
Ringer for HOME
Ringer for CELL1
Ringer for CELL2
SELECT
SET
Ringer Volume
Ringer for HOME
Ringer Volume
Ringer Melody
SELECT
OFF
OFF