AT&T EP5632 User Manual
Page 57
53
System setup
Call Screening
By default,
Call Screening is on. Call Screening
allows you to listen to a caller leaving a message
on the answering system.
To change this feature's setting:
1. Press the
MENU softkey on the telephone base
to enter the main menu.
2. Press the
UP and DOWN NavKeys to highlight
Answering System, then press the SELECT
softkey to enter the
Answering System menu.
3. Press the
the
DOWN NavKey to highlight Call
Screening, then press the SELECT softkey.
4. Press the
UP and DOWN NavKeys to highlight
to highlight
On or Off, then press the SET softkey to save the
setting.
Remote Code
By default, the
Remote Code is 5000. To access
your answering system remotely from any touch
tone phone (page 92), you need to enter the four-
digit remote access code.
To change the remote access code:
1. Follow steps 1 through 2 in the above section.
2. Press the
UP and DOWN NavKeys to highlight
Remote Code, then press the SELECT softkey.
3. Enter your desired four-digit code by using the:
Enter your desired four-digit code by using the:
• Dial pad keys (
0-9) to enter a code.
•
LEFT and RIGHT NavKeys to move the cursor
left and right.
•
UP and DOWN NavKeys to change the digit.
4. Press the
SET softkey to save your setting.
Answering System
Record Memo
Number of Rings
Call Screening
SELECT
Call Screening
POn
Off
SET
Answering System
Number of Rings
Call Screening
Remote Code
SELECT
SET
Remote Code
5
000