Clear-Com HX System Frames - Manual (Page 134)

• When a panel within the group answers the call, the responding panel key flashes
green to indicate that there is an active link between the responding panel and the
calling panel.
Note: Panels can only answer one management call at a time. If another Talk
key is pressed, the link with the management call is broken.
Note: When an incoming call is answered, the panel keys on all panels other
than the responding panel key is solid green.
• The responding panel key is solid red when the responder is speaking.
An active link between a management panel and a caller is ended if the management
panel:
• Calls another port
• Answers another incoming call
The audio from the caller is then routed to the group loudspeaker.
If another management call is received while there is already an active management call,
the audio of the new call is routed to the management group loudspeaker until it is
answered by a panel within the management group, or the timeout expires. This will not
interfere with the first call.
If there is an active link between a caller and a management panel and a different
management panel attempts to link to the caller, the following applies:
• If the active management panel Talk key is pressed, audio is sent from both
management panels to the caller, but the interrupting management panel receives
no audio from the caller.
• If the active management panel Talk key is not pressed, the original active link in
broken, and a new link is created between the interrupting management panel
and the caller. This means that you can transfer conversations from one
management panel to another.
5.44.6 Fixed group soft mode options
The Soft Mode Options list display items which relate to the Soft Mode available on
certain panel types. Currently this is restricted to Sort Groups.
To enable/disable Soft Mode Options
1) Open the Fixed Groups screen by selecting the Fixed Groups link on the
Configuration menu
2) Create a Fixed Group or select a Fixed Group that was been previously created.
3) Expand Soft Mode Options in the Properties window.
4) Select the required options:
• Default Assign as Talk and Forced Listen. When true the default for a key
assigned to this label is Talk and Forced Listen.
• Enable Assignment as Listen. This must be enabled to allow a V-Series
panel operator to assign a listen key to this label. If it is not enabled a V-Series
panel operator cannot assign a listen key to the label.
134 Eclipse EHX Software User Guide