Clear-Com HX System Frames - Manual (Page 84)

5.21 Port properties
Port Properties enables the EHX operator to tailor the behavior of a selected port.
To view the port properties for a particular port:
1) Select the required interface card.
2) Select the relevant port and the Port Properties for that Port are displayed.
Note: By default the Port Properties tabs is initially not displayed in expanded form. To expand
a class of advanced settings click on the > beside the heading. The Port Properties that
are available depend on the type of device the port is configured for.
The Port Properties options for panels and Interfaces are described below.
5.21.1 Assignment panel (AP) panel options
The Port Properties options for an AP panel (Assignment Panel) are as follows:
• Fixed Group Assignment
• Set to True or False (default False). Allows the panel operator to select ports to
be assigned to a fixed group.
• IFB Assignment
• Set to True or False (default False). Allows the panel operator to select ports as
sources to be assigned to an IFB.
• Partyline Assignment
• Set to True or False (default False). Allows the panel operator to select ports as
fixed members of a party line.
• Applies to:
• V-Series and I-Series Panels only.
5.21.2 Auxiliary relay options
The Port Properties options for an Auxiliary Relay are as follows:
Has associated relay
The port device controls a relay (similar to secondary action).
For example if an external device is connected to an MVX-A16 and that external device
can control a relay the relay can be controlled through this setting.
Applies to:
Direct connections.
5.21.3 Basic options
The following Basic options are available:
Port number
The port number the device is configured on.
Note: Not available on Concert panels.
84 Eclipse EHX Software User Guide