Clear-Com HX System Frames - Manual (Page 99)

5.21.15 Attached control options
The Port Properties options for an Attached Control are as follows:
Secondary action
The Secondary action allows a Control to be attached to a Port. Whenever a talk route key
to the Port is pressed, the Control attachments such as Relays, Routes or Speed Dials,
are activated.
Vox action
The VOX action allows a Control to be attached to a port. Whenever the audio level at the
Port reaches the Audio Detection Threshold defined in Voice Operated Switch section of
Advanced Settings the Control attachments such as Relays, Routes or Speed Dials, are
activated.
Note: Not available on Concert panels.
Applies to:
On all port devices except Trunk.
5.21.16 DTMF options
The DTMF options are used to configure either the TEL-14 interface module or an external
telephone hybrid for incoming calls. They are also used to control access to the system by
the external caller.
The setups for outgoing calls are configured on the MVX-A16 card which controls the
outgoing DTMF on TEL-14 interface modules.
Access prompt
Controls whether the port sends DTMF access prompt tones and may be enabled or
disabled. This allows the incoming caller to receive access prompts. The default is
enabled.
Assign DTMF codes
Assigns a DTMF selector code to a specific audio path. This allows the incoming caller to
make various preselected links within the matrix by entering a specific code.
Enable DTMF passcodes
This enables the use of passcodes that are set up using the Preferences > DTMF
Settings tab. Up to eight DTMF passcodes can be set up for a system and each passcode
can be enabled for a port using a drop-down menu.
When enabled incoming callers must enter a 4 digit passcode before being allowed
access.
First code only
If this is enabled DTMF tone detection is disabled after the first valid DTMF code has been
received. Default is disabled.
Note: Only on TEL-14.
99 Eclipse EHX Software User Guide