Clear-Com HX System Frames - Manual (Page 174)

Figure 6-15 Editing IVC-32 Card Settings
6.5.1 IP port
The port the panel uses to log in to the IVC-32 card. This is the internal IP port if the panel
is on the same LAN, or the external IP port if not.
This parameter should not normally be changed from the default value unless all the IP
panels or Concert server are also updated to use the new port number. If this is not done
the IP panels or Concert server cannot communicate with the IVC-32 card. Eclipse system
administrators are advised to check with network administrators or IT that the default port
may be used without causing a conflict with any other application on the network.
If the IP port number is changed ports 42001 and 1300 should not be used as these ports
are already used by EHX. The Eclipse HX system administrator should check with the
network administrator or IT to obtain a port number to use.
IP address
The IP address of the IVC-32 card that the panel tries to log in to. This is the internal IP
address if the panel is on the same LAN, or the external IP address if not.
Subnet mask
Subnet mask used by the IVC-32 card to define the address range the card can access.
Commonly set to 255.255.0.0 or 255.255.255.0.
Default gateway
The address of the gateway to be used to communicate with external devices such as IP
panels and Concert clients over the IP network.
174 Eclipse EHX Software User Guide