Clear-Com HX System Frames - Manual (Page 75)

If the matrix is available on the network (the correct firmware has been loaded and the IP
address has been set up), the hardware can be auto-detected by clicking Detect New
Hardware at the top of the screen.
Note: Detect New Hardware is only visible if the Port List Options drop down list at the top of
the screen is active.
5.7 Adding an MVX-A16 card
The MVX-A16 is a 16 port matrix card designed to connect 16 intercom panels, interfaces
or external four-wire devices to the Eclipse HX System (Eclipse HX-Omega, Eclipse HX-
Median and Eclipse HX-Delta only). MVX-A16 cards can be added, removed and viewed
in the matrix hardware screen.
Figure 5-4 Eclipse HX Empty Slots
To add an MVX-A16 card:
1) In Hardware > Cards and Ports, navigate to an available slot number (marked
Empty). Do either of the following:
• Double click the slot.
• Right click the slot and select Set Card Type.
2) A drop-down menu is displayed, listing the available card types. Select MVX-A16.
3) Repeat this step for the number of required MVX cards.
Note: MVX-A16 cards must already be fitted into the Eclipse HX matrix with no empty slots left
between the cards.
Note: You can also change an existing card by right-clicking the slot and selecting Set Card
Type. (Changing the type of card deletes any ports, panels and keys that exist on the
card).
75 Eclipse EHX Software User Guide