Hach-Lange Sigma SD900 Portable - Manual (Page 23)

21
Installation
3.3.3 Multiple bottle installation
Use multiple bottles to collect samples into separate bottles or into
more than one bottle. A distributor positions the sample tube over
each bottle. Position the bottles in the sampler base as shown in
section 3.3.3.1 . Refer to Figure 5 on page 17 for a diagram of
required components.
3.3.3.1 Bottle number 1 position
Position the first sample bottle (number 1) under the label in the
sampler base (see
Figure 8 ). Place the remaining bottles in
increasing number in the direction indicated by the label.
Figure 7 Full bottle shut-off installation
1 Inside tube fitting 4 Slot in full bottle shut-off base plate
2 Threaded hole 5 Thumb screw on full bottle shut-off assembly
3 Retainer pin