Hach-Lange Sigma SD900 Portable - Manual (Page 27)

25
Installation
Installation procedure:
1. Clean the sample bottles as described in section 3.3.1 .
2. Place the bottles in the base:
• Compact base: arrange the bottles so that the first bottle is
located under the arrow label (
Figure 8 on page 22 ).
• Standard base: arrange the bottles so that the first bottle is
located under the label marked 24 BOT (
Figure 8 on
page 22 ).
3. Place the retainer over the bottles with the knobs pointing up.
Secure with the straps ( Figure 11 ).
Note: If using 350-mL glass bottles with the standard base, place the
bottles around the outside of the retainer.
4. To keep samples cool, fill the sampler base with ice after the
bottles are in place.
Note: The time that it takes the ice to melt varies with the amount of
ice used, the external temperature and sample temperature.
5. Place the midsection over the base, program the sampler and
install in the field.
Figure 11 24 bottle installation
1 Standard sampler base (Cat. No. 8976) 5 Retainer (Cat. No. 1422)
2 350-mL glass bottles (24x) 6 Compact sampler base (Cat. No. 8975)
3 Retainer (Cat. No. 2189) 7 575-mL plastic bottles (24x)
4 1-L plastic bottles (24x)