Hach-Lange Sigma SD900 Portable - Manual (Page 24)

22
Installation
3.3.3.2 Two or four bottle installation
Use 2 or 4 bottles to collect samples into one-gallon bottles.
Prerequisites:
• Two or four 1-gallon plastic or glass bottles
• Retainer (Cat. No. 2190)
Note: Refer to Figure 2 on page 9 to make sure that the correct sample
bottles are used with the correct sampler base and retainer.
Installation procedure:
1. Clean the sample bottles as described in section 3.3.1 .
2. Place the bottles in the base as shown in Figure 9 . Arrange the
bottles so that the first bottle is located under the label at the
point marked 2 or 4 BOT (
Figure 8 on page 22 ).
3. Place the retainer over the bottles with the knobs pointing up.
Secure with the straps ( Figure 9 ).
Figure 8 Bottle number 1 location
1 Bottle #1 location for 24 bottles 6 Standard base
2 Bottle #1 location for 8 bottles 7 Bottle #1
3 Bottle #1 location for 2 or 4 bottles 8 Elastic straps
4 Bottle #1 location in compact base 9 Retainer
5 Compact base 10 Sample bottle