Controlled Products Systems Group 9000-080 - Manual (Page 14)

9000-065-F-9-10 12
1.4 Operator Mounting Positions
Front Position with Concrete Pad
Standard method of installation.
Front Position with Post Mount Kit
Raises operator and allows different chain heights.
Additional hardware required. Post mount kit (P/N 9000-015).
The Model 9000 operator is designed to be installed in the front, rear and center mounting positions shown on this page and
the next 2 pages. V-wheel V-rail ornamental gates are shown as examples but other gate types on the previous page can use the
same mounting setups. Once the mounting position has been selected, refer to pages 15 thru 18 for specific installation
instructions.
Top View
Idler Wheels and Chain Setup
Top View
Idler Wheels and Chain Setup
• Set operator chain idler wheels in the
bottom position.
• Optional chain tray kit may be installed.
See page 18 for more information.
• Operator’s chain idler wheels are factory set
in the top position.
See page 15 and the post mount instruction sheet included with the kit for more information about post installation.
A filler post or barrier may need to be installed between
the gate and wall area (See page 8 for more information).
A filler post or barrier may need to be installed between
the gate and wall area (See page 8 for more information).