Controlled Products Systems Group 9000-080 - Manual (Page 20)

9000-065-F-9-10 18
1.10 Installation of Warning Signs
This DoorKing Slide Gate Operator is shipped with two warning signs. The
purpose of the warning sign is to alert uninformed persons, and to remind
persons familiar with the gate system, that a possible hazard exists so that
appropriate action can be taken to avoid the hazard or to reduce exposure
to the hazard. See page 9 for suggested mounting positions of signs.
• Permanently install the supplied warning signs in locations so that the
signs are visible by persons on both sides of the gate.
• Use appropriate hardware such as wood or sheet metal screws (not supplied) to
install the warning signs.
1.9 DoorKing’s Chain Tray Kit
The Chain tray supporting brackets
can be mounted facing up (as shown)
or facing down depending on the
operator height.
Chain Tray
Supporting
Bracket
(Facing down)
Chain Tray
Supporting
Bracket
(Facing up)
Weep Hole
Carriage Bolts
For further information about the chain tray installation,
refer to instructions provided with the chain tray kit.
10 Ft. Segment
Chain Tray
Segments
Connection
10 Ft. Segment
A chain tray is recommended for gates longer than 20 ft. to support the weight of the chain. DoorKing offers a chain tray kit in
10 ft. sections to fit any length gate. (DoorKing P/N 2601-270 10 Ft. section)
Chain
Tray
Gate
Wall
4”
1”