Controlled Products Systems Group 9000-080 - Manual (Page 31)

9000-065-F-9-10 29
9 V battery operated transmitter mounted on gate.
Wireless Reverse Edge Sample Setup - Single Receiver
Photo Sensor and Wireless Reverse Edge Sample Setup
Closed Gate
Wall
Normally Open
Common
Normally Open
Install Jumper Wire
Common
Normally Open
Normally Open
Common
When either direction reversing edge get obstructed the gate will STOP,
then continue in the same direction after obstructed reversing edge has
been cleared until the gate cycle is complete.
When a reversing edge or photo beam get
obstructed the gate will STOP, then continue
in the same direction after obstructed
reversing edge or photo beam has been
cleared until the gate cycle is complete.
Filler Post Note: Install reversing edges on all
the gate support posts or filler post in this area
(e.g. cantilever gate installations, See below).
Wireless Note: Refer to the
instruction sheet that comes
with the receiver/transmitter
for more specific wiring and
mounting instructions.
Wiring Note: Receiver
can be wired directly to
main terminal if desired.
Wiring Note:
Receiver can
be wired
directly to main
terminal if desired.
Closing-
Direction
Reversing
Edge
Closing-
Direction
Reversing
Edge
Opening-Direction Reversing Edge
6-Pin UL 325 Terminal Wiring
Opening-Direction Reversing Edge (If filler post is used).
9 V battery operated transmitter mounted on gate.
Filler Post
(If necessary)
Edge
Transmitter
Edge
Transmitter
Power is limited
to 250 mamps.
Coax Antenna Kit
P/N 1514-073
Com
Com
24 Volt
3-Pin
Remote
Terminal
Antenna mounted
outside operator cover.
24 VAC Receiver
Place receiver in operator.
1
2
3
4
5
6
6-Pin UL 325 Terminal Wiring
Normally Open
Normally Open
Common Com
Opening-Direction Photo Beam
Normally Open
Common
Wireless Note: Refer to the
instruction sheet that comes
with the receiver/transmitter
for more specific wiring and
mounting instructions.
24 Volt
24 VAC Receiver
Place receiver in operator.
20-Pin
Main
Terminal
To #1
To #3
Photo Sensor Power Note:
Photo sensors can be powered
by the built-in convenience
outlets located on the operator
(See page 27).
Install Opening-Direction
reverse edges on the gate
support post(s) in this area.
1
2
3
4
5
6
Cantilever Gate
Coax Antenna Kit
P/N 1514-073
Antenna mounted
outside operator
cover.
OPEN Entrapment Sensor
CLOSE Entrapment Sensor
OPEN Contact Sensor
CLOSE Contact Sensor
Low Voltage Common
Low Voltage Common
OPEN Entrapment Sensor
CLOSE Entrapment Sensor
OPEN Contact Sensor
CLOSE Contact Sensor
Low Voltage Common
Low Voltage Common
1
2
3
Power is limited
to 250 mamps.
3-Pin
Remote
Terminal 20-Pin
Main
Terminal
To #1
To #3
1
2
3