Diamond Products SB - Manual (Page 19)

SB Wire Sawing System Applicational advice
SB_0107_e.mif Page 19
 7KH FRUUHFW FXWWLQJ GLUHFWLRQ
The work should be carried out with the
tension side (Z) of the wire since the cutting
conditions are best with this method.
The wire can be guided by means of a
deflection pulley (U) so that in the case of
sharp edges the wire does not dig in.
 )LQLVK FXWWLQJ
For finish cutting of the workpiece swing in
both swivelling pulleys so that:
1. The wire does not saw the inside of the holding
device and
2. At the end the wire is caught by the swivelling pulleys
/RFNLQJ VFUHZV RQ WKH VZLYHOOLQJ SXOOH\V
The swivelling pulley locking screws must
be tight during cutting work.