Diamond Products SB - Manual (Page 41)

SB Wire Sawing System Maintenance
SB_0107_e.mif Page 41
 0DLQWHQDQFH
 0DLQWHQDQFH WDEOH
Carry out the following maintenance work
within the given intervals so that the following
are guaranteed:
- User safety
- Optimum performance
- Ready-for-use at any time
 5HSDLUV
Before maintenance work dis-
connect the SB from the mains!
0DLQWHQDQFH
LQWHUYDO
7DVNV 5HPDUNV
If there is a risk of frost at the
end of work Drain water and blow out lines See operating instructions for the drive unit
used
After every cut Check flattening of wire If unevenly worn change twists
Daily Check rims on drive and deflection pulleys Replace rims if worn
Check bearings on drive and deflection pulleys If worn replace drive and deflection pulleys
Check clamping cylinder for oil loss In the event of oil loss or defects seal or
replace cylinder
Every 200 operating hours Major service To be carried out by HYDROSTRESS or an
authorized representative
Components other than those described in
the maintenance section may only be
exchanged by personnel who have been
trained by HYDROSTRESS.