Diamond Products SB - Manual (Page 38)

Run up wire saw SB Wire Sawing System
Page 38 SB_0107_e.mif
 2SHUDWLRQ
l Do not change the position of the selection
switch (4) again!
l Regulate feed pressure with rotary control-
ler (1)
 ,QWHUUXSWLRQ RI FXW
To achieve easier starting up of the wire in the
existing cut at a later stage, the cut should be
"freed" by operating the wire for a few
moments.
l Let the wire run in the cut without any feed
until the main pressure has reduced by
about 20-40 bar.
l Once the wire runs with significantly less
main pressure, switch it off and also turn off
the water.
 (QG RI FXW
l At the end of the cut move out of the cut
with reduced feed pressure to ensure trou-
ble-free capturing of the wire on the swivel-
ling pulleys.
l Once the wire has been captured by the
swivelling pulleys, switch off the wire and
turn off the water.
 7HUPLQDWH RSHUDWLRQ
l Close off and disconnect water supply
l Withdraw mains plug
l Uncouple hydraulic hose and wind it up
l Uncouple water hose and wind it up
l Disconnect cable and wind it up