Diamond Products SB - Manual (Page 27)

SB Wire Sawing System The diamond wire
SB_0107_e.mif Page 27
3UHYHQW IODW ZHDU VLQWHUHG DQG HOHFWUR
SODWHG ZLUHV
- To prevent flat running of the wire
- To reduce flat wear on the wire
To achieve a stable roundness of the wire
during operation the wire should be frequently
and systematically twisted in an anticlockwise
direction. This will cause a constant change in
the position of the individual diamond beads
with respect to one another. This is mainly
important during lengthy cutting operations.
7ZLVWLQJ GLUHFWLRQ
Twisting must always be done in the anti-
clockwise direction since otherwise the wire
strands of the steel wire would be unwound.