Diamond Products SB - Manual (Page 26)

The diamond wire SB Wire Sawing System
Page 26 SB_0107_e.mif
 3UHSDUDWLRQ RI ZLUH HQGV
:RUNLQJ VWHSV IRU ERWK W\SHV RI ZLUH
1. Cut wire with cutting wheel (one bead is always lost),
(see Page 29) SB_0107_e.fm
2. Pull off steel spring (with side cutter)
3. Cut plastic casing neatly from steel wire (with sack
knife)
l For cutting the wire only use an angle
grinder with a 1.6 mm cutting wheel
Cutting wheel 38647
 $YRLGLQJ RXWRIURXQG ZHDU
7ZLVW ZLUH
To avoid out-of-round wear on the diamond
beads, both types of wire should be twisted in
an anticlockwise direction before connection.
Knuckle connection: Twist inwards after pressing
Repair sleeve: Twist inwards before pressing
The steel wire must be absolutely free from
plastic residues before pressing. Otherwise
the wire could be torn from the pressing unit.
Caution: Risk of cutting with
knife! Carry out cutting move-
ments so that no injuries can
occur!
Cutting with other tools is not recommended
since the wire ends may not be sufficiently
accurate and may be cut at an angle.
In the case of short wire contact lengths
special care is necessary since with such
applications the wire can very easily wear
out-of-round.
Do not apply too strong a tensile force to the
wire!