Diamond Products SB - Manual (Page 35)

SB Wire Sawing System Store wire
SB_0107_e.mif Page 35
 6WRUH ZLUH
 6WRUH ZLUH 
VW
VWHS
1. If the rocker with the drive pulleys has moved to the
upper stop (A), first of all move it away
2. After moving away the wire shut down the machine
 6WRUH ZLUH 
QG
VWHS
1. Pull wire by hand from the machine (B). In doing this
the rocker together with the drive pulleys is pulled
downwards by the effect of the travelling block (B1).
 6WRUH ZLUH 
UG
VWHS
1. Cross over wire in anticlockwise direction (C)
2. Place upper part of loop over the next free drive pul-
ley
3. Place lower part of loop over the next free deflecting
pulley
 6WRUH ZLUH 
WK
VWHS
1. For each further wire storage step place the roller
guide (R) one position further to the right (1 step)