Diamond Products SB - Manual (Page 32)

The diamond wire SB Wire Sawing System
Page 32 SB_0107_e.mif
2SHUDWLRQ RI SUHVVLQJ FODPS
1. Connecting pin
2. Pressing jaws
3. Resetting and safety sleeve
4. Pressing lever
,QVHUW SUHVVLQJ MDZV
l Open connecting pin (1) and slide in the
pressing jaws (2)
l Insert connecting pin (1)
3UHVV FRQQHFWRUV
l Place sleeve right on the end of the wire
and place in pressing clamp
l Turn resetting and safety sleeve (3) to
release pressing lever (4)
l Operate press lever (4) several times until
you hear a "click", repeat 3 times
l Turn resetting and safety sleeve (3) so that
the piston travels back with the lower press-
ing jaw
Warning: Ensure that the 8 tonne
press is used.
The 5 tonne press is not strong
enough for this task!