Diamond Products SB User Manual
Page 31
SB Wire Sawing System
The diamond wire
SB_0107_e.mif
Page 31
7RROV
To connect or repair the wire you need:
Repair sleeve
DSZU-01114-94
600045
or
Knuckle connection
DSZU-01114-95
724036
Replacement pins for
knuckle connection
DSZU-01114-98
724037
Pressing clamp HT 80
117984
Cutting wheel 1.6mm
38647
Angle grinder
Knife
Side cutter
Assembling and riveting device for knuckle connection860404
$VVHPEO\ GHYLFH IRU NQXFNOH FRQQHFWLRQ
([SODQDWLRQ DQG IXQFWLRQ
Opening the wire:
Place wire with closed knuckle connection into
the device and align it centrally. Carefully drive
out the spindle with the pin.
&RQQHFW ZLUH
(OHFWULFDOO\ERQGHG ZLUH
This wire does not change its diameter as it
wears.
Therefore when connecting various worn wires
together it is unnecessary to take account of
the diameter.
6LQWHUHG ZLUH
In the event of wear different diameters may
arise since the diameter changes.
Therefore when connecting various worn wires
together it is necessary to take account of the
diameter.
Never connect wires of different diameters:
The maximum difference between diame-
ters should be 0.2 mm.