Diamond Products SB - Manual (Page 28)

The diamond wire SB Wire Sawing System
Page 28 SB_0107_e.mif
6LQWHUHG ZLUH
When first used a sintered wire must be
twisted about 1 - 1.5 times per metre length in
an anticlockwise direction.
To ensure uniform wear on the wire beads,
change the twists of the wire often by about +
or - 30%, but never under 1 x per metre of
wire. Changing of the twists should take place
after every cut.
(OHFWURSODWHG ZLUH
When first used an electro-plated wire must be
twisted about 0.5 times per metre length in an
anticlockwise direction.
To ensure uniform wear on the wire beads,
change the twists on the wire often, but never
under 1 x and never more than 1.5 times per
metre of wire.
Changing of the twists should take place after
every cut.
6LQWHUHG ZLUH 7ZLVWLQJ DW WKH
VWDUW RI ZRUN
/HQJWK RI ZLUH 7RWDO WZLVWV
5 metres 5 - 7 x twists
7.5 metres 8 - 11 x twists
10 metres 10 - 15 x twists
15 metres 15 - 22 x twists
$GYDQFHG RSHUDWLRQ
([DPSOH  P VLQWHUHG ZLUH
After 1
st
cut
+ 3 x twists
After 2
nd
cut
+ 3 x twists
After 3
rd
cut
Loosen x 3
After 4
th
cut
+ 3 x twists
After 5
th
cut
Loosen x 3, etc.
(OHFWURSODWHG ZLUH 7ZLVWLQJ DW
WKH VWDUW RI ZRUN
/HQJWK RI ZLUH 7RWDO WZLVWV
5 metres 2-3 turns
7.5 metres 4 turns
10 metres 5 turns
15 metres 8 turns
$GYDQFHG RSHUDWLRQ
([DPSOH  P HOHFWURSODWHG
ZLUH
After 1
st
cut
+ 3 x twists
After 2
nd
cut
+ 3 x twists
After 3
rd
cut
Loosen x 3
After 4
th
cut
+ 3 x twists
After 5
th
cut
Loosen x 3, etc.