Darex XPS-16 Operating Instructions - Manual (Page 100)

User Manual Page 5
Replace Chuck Spindle Drive Belt
1. Take the knob and jaw assembly and position
all jaws in slots. Holding in your hand, align
the black diameter detect rod in the
corresponding notch in the spindle cone. (See
drawing below). Make sure jaws are in spindle
slots. Slide the assembly all the way in until it
stops.
2. With the solenoid engaged in the locking
hole, rotate the chuck to the illustrated
position.
3. Slip the knob retainer under the knob and
locate threaded holes under counter bored
holes in the knob. (Note the dotted lines).
Hold in position with your finger and secure
with 2 cap screws. Rotate the chuck 180°
and repeat the process. Replace the cover
and secure with 3 button head screws.
Diameter detect rod
Notch
Top
Bevel side down