Darex XPS-16 Operating Instructions - Manual (Page 122)

User Manual Page 30
Removing and Replacing Grind Motor Brushes
1. Refer to Removing and Replacing Grind Motor
Assembly instructions to remove and replace
the motor. See Section 24 Schematics and
Work Instructions page 27.
2. Once the motor is removed, note the slotted
brush retaining screws on each side of the
motor.
3. Unscrew and check brushes one at a time not-
ing how they were oriented in the guide.
Marking them is a good idea.
4. Check each brush for damage to the springs
or for excessive wear. They should measure
no less than .275 from the lowest point of the
radius to the top of the brush.
5. If either one needs replacement you must re-
place both brushes with new ones. If not,
carefully replace them the same way they
came out.
6. If you are replacing with new brushes, be sure
to install them with the radius of the brush in
line with the rotation of the motor.
7. After brushes are installed, refer to Removing
and Replacing Grind Motor Assembly instruc-
tions to replace the motor. See Section 24
Schematics and Work Instructions page 27.