Darex XPS-16 Operating Instructions - Manual (Page 29)

29
• After offsets are entered, touch the
“SAVE” button to store the “New” infor-
mation and transfer you back to the pre-
vious screen. Changes to the wheel offset
will return to previous setting unless the
“PERMANENT FILE SAVE” is used. See
Page 27.
• Selecting “CANCEL” will delete any
unsaved data, retrieving the most re-
cently saved information, transferring you
back to the previous screen.
Split Point Offset Screen
Selector
• In this screen you can offset 5 different areas
of the split point. A. Depth of split, B. Center
of split, C. Fan Angle D. Split Angle and E.
Radius Split.
Split Point Offset Screen
Α. Depth of split: Increase depth of split
using the +Z button , or decrease depth
of split using the -Z button
Β. Center of split: Use the +X button , to
move the center split line towards the
chisel line (removes more material) on
the drill point, or the -X button , to move
it away. (removes less material)
Α. Fan Angle: This option is more for drill aes-
thetics than functionality. Utilizing this option
may be necessary to remove more or less of
the heel to mimic a certain style. The selected
split angle, amount of relief and degree of the
point angle will determine the actual fan angle
produced. Regard the degree entered as a
reference number only, the fan angle pro-
duced has a tolerance of +/- 15°.
• Touch the “FAN ANGLE” button, the
Number Key Pad will come up.
• Type in the desired fan angle degree.
• Touch the “SAVE” button to store the
“New” information and transfer you back
to the previous screen.
• Selecting “CANCEL” will delete any
unsaved data, retrieving the most re-
cently saved information, transferring
you back to the previous screen.
D. Split Angle: Type in the desired split angle,
typically 120° to 130°. By increasing the rota-
tion of the split angle, the split portion of the
drill meets the cutting lip at a greater angle,
which will give that area more strength and
durability. This added split angle creates a
pointed profile at the very center of the drill,
which will produce a self-centering effect and
reduces drill point walking at the start of a
hole.
A
B
D
E
C
Fan Angle
Split Angle
Past Center To Center Not To Center
Past Center To Center Not To Center
Touch Screen Details