Darex XPS-16 Operating Instructions - Manual (Page 31)

31
justment of the C axis will not be necessary.
Adjustment may be needed if the factory de-
fault allows too much rotation and the grind-
ing wheel nicks the cutting edge.
• The +C button will stop the rotation of
the cutting edge further away from the
grinding wheel.
• The -C button will stop the rotation of
the cutting edge closer to the grinding
wheel.
Refer to page 35 for details on R-Split
offsets.
• Touch the “SAVE” button to store the
“New” information and transfer you back
to the previous screen.
• Selecting “CANCEL” will delete any
unsaved data, retrieving the most re-
cently saved information, transferring
you back to the previous screen.
Honing Wheel Offset Ad-
justment Screen Selector
• You will have up to .125 range of adjustment
to change the position of drill to the face and
edge of the honing brush.
Honing Wheel Adjustment Screen
Use this screen to adjust the drills position relative
to the honing brush.
• To move the drill position across the face
of the brush, adjust the wheel “EDGE”.
Use the +X button, to move to the hone
brush to the right or the -X button, to
move it to the left.
• To adjust the depth the drill travels into
the brush, adjust the wheel “FACE” ac-
cordingly; use the +Z button, to move
drill deeper into the hone brush or the -Z
button, to back out of the hone brush.
• After adjustments are entered, touch the
“SAVE” button to store the “New” infor-
mation and transfer you back to the pre-
vious screen.
• Selecting “CANCEL” will delete any
unsaved data, retrieving the most re-
cently saved information, transferring you
back to the previous screen.
•
Hone Timing Adjustment
Screen Selector
• Adjust the length of time the cutting edge is in
the honing cycle. Select from .010 up to 60.0
seconds. To produce a larger radius, increase
the length of time the cutting edge is in the
hone cycle.
Hone Timing Adjustment Screen
• Type in desired seconds of hone time. For
more information on “Honing” see page 53
• After hone time is entered, touch the
“SAVE” button to store the “New” infor-
mation and transfer you back to the pre-
vious screen.
• Selecting “CANCEL” will delete any
unsaved data, retrieving the most re-
cently saved information, transferring you
back to the previous screen.
Contrast Adjustment
Screen Selector
• Adjust the contrast of the LCD screen. Select
10 as darkest thru 65 as lightest.
NOTE: the factory default is 42
Touch Screen Details