Darex XPS-16 Operating Instructions - Manual (Page 48)

48
TO REINSTALL:
Reinstall in reverse order, making sure the diame-
ter detector rod is oriented in spindle correctly.
CAUTION: If diameter detector rod is rein-
stalled improperly, damage to rod will oc-
cur.
• After chuck jaw assembly is properly replaced
and before the 4; 4mm bolts are in place,
open or close the chuck knob until the bolt
hole pattern on the chuck knob is in alignment
with the bolt hole pattern on each of the
chuck knob retainers.
Call Darex to replace
any Chuck knob retainers with a single side
bevel.
The position of the chuck knob retainers may
need to be raised or lowered to meet the bolt hole
pattern on the chuck knob. Carefully insert bolts
and tighten.
Chuck knob retainer showing bevel
Top
Chuck Exploded View
Chuck Information
PP12255FF