Darex XPS-16 Operating Instructions - Manual (Page 30)

30
Touch the Split Angle button, the Num-
ber Key Pad will come up.
• Type in the desired split angle degree, a toler-
ance of +/-5° can be expected.
• Touch the “SAVE” button to store the
“New” information and transfer you back
to the previous screen.
• Selecting “CANCEL” will delete any
unsaved data, retrieving the most re-
cently saved information, transferring you
back to the previous screen.
*Do not use the “Split Point Offset Screen”
to compensate for changes in the split point
due to wheel wear or a wheel change. Make
all adjustments for centering split or mate-
rial removal amount in “Grinding Wheel Ad-
justment Screen”.
Refer to page 28
E. Radius Split Offset: The R-Split button
will appear and will be functional only
when a web thickness value is manually input
into the “Web Thickness” Screen. The “Web
Thickness” Screen is located on the “Main Set
up” page. The XPS-16 calculates 30% of the
entered web thickness and uses that as the
offset default. If this does not produce the
amount of radius desired, follow the steps be-
low. For detailed information
Refer to page 35
• Touch the “R-Split” button on the Split
Point Offset Screen; the Radius Offset
Adjustment Screen will come up.
Radius Offset Ad-
justment Screen
• Touch the “OFFSET” button, the offset
keypad will come up.
Radius Offset Key Pad
• Adjust the radius offset by entering an offset
larger or smaller than the factory default.
• Type in the offset amount. An offset amount
of .001 will produce the largest possible radius
on that drill. As your offset gets larger, the
radius will become smaller.
• Touch the “SAVE” button to store the
“New” information and transfer you back
to the previous screen.
• Selecting “CANCEL” will delete any
unsaved data, retrieving the most re-
cently saved information, transferring you
back to the previous screen.
Adjusting The Rotation of the ARC/C
axis
• Adjust the stopping point of the C axis or ARC/
Rotation of the radius. The factory default is
5°. This will stop the cutting edge of the drill
5° from the grinding wheel. In most cases ad-
Touch Screen Details