Darex XPS-16 Operating Instructions - Manual (Page 63)

63
Insert Drill Alarm
• No drill has
been detected
Insert drill or
check to see if
drill is loose
and has
pushed back in
the chuck
Remove Drill Alarm
• Drill has
been left in
chuck during
Self Test Ini-
tialization pro-
gram and be-
fore machine
goes into the
Lube cycle.
Remove the
drill from the
chuck
Cutting Edge Detection Alarm
• If cutting edge is not detected
within one full revolution you will see
this alarm. For more information see
page 65 .
Material Take Off Alarm #1
• Drill not pushed up against the
stop.
• To trip the limit switch, reset drill,
pushing the tip into the stop while
tightening the chuck.
• MTO sensor failed, contact factory.
• Use compressed air to clean.
Material Take Off Alarm #2
• Use compressed air to clean lens
• MTO sensor failed, contact factory.
Grind Motor Error
• The grind motor fuse is
blown.
• No grind motor current
sensed.
Time Out Error
• In the grinding process
too long. Clean or replace
grinding wheel.
Oil Lubrication Screen
• Self-lubrication cycle necessary
Refer to information on page 79 for
details.
Trouble Shooting Icons
Trouble Shooting Section