Removing and replacing the a-axis (swing) sensor – Darex XPS-16 Operating Instructions User Manual
Page 106
Advertising
User Manual Page 11
Removing and Replacing the A-Axis (Swing) Sensor
Removing and Replacing the A-Axis (Swing)
Sensor
1. Locate the marked swing sensor cable and
unplug the sensor connector.
2. Note the access hole in the dust shield cover.
3. Swing the dust shield up or down to access
the two 2mm screws securing the sensor.
4. Unscrew the screws and remove the sensor.
5. To replace the sensor reverse the process and
snap the connector together.
Advertising