Darex XPS-16 Operating Instructions - Manual (Page 120)

User Manual Page 28
8. Remove the 4 screws and washers holding the
motor in place.
9. Slide the motor down the slotted bracket and
out of the machine. Remove the cooling hose
connected to the motor.
10. To replace the motor assembly, the machine
must in the belt change position.
11. Reconnect the cooling hose and slip the motor
shaft with the pulley in place up the slotted
bracket and aligned with slots and screw hole.
12. Install screws and washers just until they
bring surfaces together.
13. Reconnect motor wires and zip tie if needed.
14. Refer to
Grind Motor Belt Replacement instruc-
tions for belt replacement and proper belt ten-
sion. See Section 24 Schematics and Work In-
structions page 29.