Darex XPS-16 Operating Instructions - Manual (Page 32)

32
Contrast Adjustment Screen
• Adjust screen contrast, using “ARROW
UP” to increase the contrast number,
making the screen lighter or “ARROW
DOWN” button to decrease the number,
making the screen darker.
• After adjustment is entered, touch the
“SAVE” button to store the “New” infor-
mation and transfer you back to the pre-
vious screen.
• Selecting “CANCEL” will delete any
unsaved data, retrieving the most re-
cently saved information, transferring
you back to the previous screen.
Touch Key Delay Screen
Selector
• Adjust the sensitivity of the touch screen but-
tons. Select 50 as the most sensitive setting
and up to 550, as the least sensitive.
NOTE: Factory default is 200
Touch Key Delay Screen
• Adjust Touch Key sensitivity according to your
touch, using the “ARROW UP” button
will increase the number, decreasing the
sensitivity of the touch screen or the
“ARROW DOWN” button will increase
sensitivity, decreasing the number.
• After adjustment is entered, touch the
“SAVE” button to store the “New” infor-
mation and transfer you back to the pre-
vious screen.
• Selecting “CANCEL” will delete any
unsaved data, retrieving the most re-
cently saved information, transferring you
back to the previous screen.
Cycle Start
• Start the sharpening process by touching
“CYCLE START”. If machine door is open you
will get the Open Door alarm. Close door and
press “CYCLE START” to continue.
Cycle Stop
• By touching the “CYCLE STOP” button , you
will immediately interrupt the sharpening proc-
ess; the machine will pause and remain idle.
You cannot resume sharpening once the
sharpening cycle
has been inter-
rupted.
• The Home
Screen will ap-
pear.
• To abort the sharpening cycle, touch the
“HOME” Icon, the sharpening program
will be aborted, the grinding motor will
shut down and the sharpening fixture
will return to its home position.
• If the “HOME” button is not selected, the
machine will start a 59 second count
down, at the end of the countdown, the
sharpening program will then be aborted, the
grinding motor will shut down
and the sharpening fixture will
return to its home position. The
Main Set-up Screen will come
up.
• After re-chucking the drill, press “CYCLE
START”. The sharpener has retained the
previous set up information.
Touch Screen Details