IAI America RCP2W-GRLS - Manual (Page 82)

72
9. Maintenance/Inspection
Cover
Cover
(2) How to apply grease
[Small Two-finger Slide Type (RCP2-GRSS, RCP2W-GRSS)]
[Small Two-finger Lever Type (RCP2-GRLS, RCP2W-GRLS)]
[1] In the case of dust-proof specification small
two-finger slide type (RCP2W-GRSS), remove
the rubber cover. Rubber covers have
“notches” on them. Detach the notches when
removing the rubber cover.
Dust-proof specification small two-finger
slide type (RCP2W-GRSS)
[2] Using a 2.5-mm Allen wrench, turn the
opening/closing screw at the center of the
fingers to move the fingers toward the stroke
center.
[3] Using a grease spray gun, apply grease (on
steel balls) between the fingers and finger
guides. (Spray grease in four locations for less
than 1 second each.)
After spraying, turn the opening/closing screw
to move the fingers back and forth several
times to spread the grease evenly. Remove
excess grease or grease spatters in
surrounding areas.
[4] Attach the rubber cover in the case of dust-
proof specification small two-finger slide type
(RCP2W-GRSS).
Dust-proof specification small two-finger
slide type (RCP2W-GRSS)
Finger
Finger guide
Open/close screw
Grease application
Caution
•
•
In case the grease got into your eye, immediately go to see the doctor to get an appropriate care.
After finishing the grease supply work, wash your hands carefully with water and soap to rinse
the grease off.