IAI America SSPA - Manual (Page 82)

14. Motor Replacement Procedures
74
Cable mounting cover
(3) Removing the cable mounting cover
Remove the three bolts used to secure the cable mounting cover to the cable using an Allen wrench of 2.5
mm across flats.
(Note) After the motor is replaced, the motor cables must be installed on the cable affixing cover. Before
removing the affixing cover, mark the cables so that their installation positions can be checked later
on.
(4) Removing the motor cover
Remove the two bolts used to secure the motor cover using an Allen wrench of 2.5 mm across flats for ISB
and ISPB-SXM/SXL, or 3 mm across flats for all other models
Two of these bolts are found below the motor at locations further back in the motor cover.
The unit will look like below after the motor cover is removed.
Motor
Motor cover Bolts affixing the motor cove