LEESON FHP Series Chassis Mount Variable Speed Drives - Manual (Page 25)

15 Installation
• It is recommended that the drive be oriented with the
chassis vertical for best heat dissipation. Horizontal
mounting, while acceptable, may require some thermal
derating.
• Six 0.19-inch (5 mm) wide slots accept #8 pan head
screws. Fasten either the large base or narrow flange of
the chassis to the subplate.
• Drive components are sensitive to electrostatic fields.
Avoid direct contact with the circuit board. Hold the drive
by the chassis only.
Mounting
Warning
DO NOT install, rewire, or remove this control with
input power applied. Doing so may cause fire or
serious injury. Make sure that you read and
understand the Safety Warnings before attempting
installation.
NOTE: Horizontal mouting may require derating the
drive. See your LEESON representative for more
information
ƽ