Teledyne LeCroy SierraFC M8-4 User Manual User Manual
Teledyne LeCroy Equipment
Advertising
Table of contents
Document Outline
- Contents
- Introduction
- Analyzer Overview
- Receiving Your Analyzer
- Unpacking the Analyzer
- Analyzer Features
- LEDs
- Status and Configuration Display
- Installing Your Analyzer
- Hardware Setup
- Expandability
- Connecting via Ethernet
- Connecting Via USB
- Launching Your Analyzer
- Operating in Simulation Mode
- Using the Software
- Protocol Analyzer
- Protocol Analysis
- Supported Protocols
- Easy Mode (Pre-Defined Setups)
- Main Window
- Analyzer Settings
- Capture Tab
- CrossSync Control Panel
- Patterns and Data Capture Setup
- Pre- and Post Trigger Data Capture
- Trigger Setup
- Snapshot Mode
- Manual Trigger Mode
- Pattern/Event Trigger Mode
- Timers/External
- Basic Patterns
- FCP Patterns
- ARB
- ELS
- GS
- SW
- FICON
- FCAE
- FCAE-1553
- FCAE-RDMA
- FCVI
- FCAV
- ADVB
- VSAN Basic
- VSAN-FCP
- VSAN-ARB
- VSAN-ELS
- VSAN-GS
- VSAN-SW
- VSAN-FICON
- VSAN-FCAE-ASM
- VSAN-FCAE-1553
- VSAN-FCAE-RDMA
- VSAN-FCVI
- VSAN-FCAV
- VSAN-ADVB
- Custom Frame
- Protocol Errors
- Sequential Trigger Mode
- Pre-Trigger
- Project Settings
- Advanced Mode (User-Defined)
- Display Manipulation
- Viewer Display
- Switching Views
- Bus Utilization View
- Statistical Report
- Statistical Report Toolbar
- Formatting the Statistical Report View
- Tools
- Quick Filtering
- Using Cursors and Bookmarks
- Quick Search
- Viewer Configuration
- Port Configuration
- Port Calibration
- Software Settings
- Update Sierra Device
- Setup IP
- Set Address Alias
- All Connected Devices
- Help Menu
- FC InFusion
- China Restriction of Hazardous Substances Table
- How to Contact Teledyne LeCroy
- Index