Teledyne LeCroy SierraFC M8-4 User Manual User Manual
Page 153
SierraFC M8‐4 Protocol Analyzer User Manual
153
Easy Mode (Pre‐Defined Setups)
Teledyne LeCroy
Timeout
Selecting Timeout for the pattern opens the Add Timeout Pattern dialog.
Figure 2.119: Add Timeout Pattern Dialog
Select a pattern for Start Events or End Events, enter a Timeout value, select units, and
then select Trigger Mode:
Trigger If the ‘End Event(s)’ occur(s) before the timer expires
Trigger if the timer expires before ‘End Event(s)’ occur(s)
Note:
You cannot select a Timeout pattern if you select any other pattern as the trigger condition.
External Trigger Pattern
You can trigger on an external trigger. To set up the trigger, click the External Trigger
pattern. In order to select an External Trigger refer to the
Figure 2.120: Add External Trigger Pattern Dialog